Vapors harmful. Keep out of reach of children.
Fiberglass Hawaii Guide Wrap epoxy resin system is a low viscosity, clear, two-component, ultraviolet-resistant epoxy laminating system, designed for the manufacturing of high strength, lightweight composites with fiberglass, aramid, or carbon fibers. Can be used on most surfaces including wood, fiberglass, polystyrene, polyurethene, and PVC foams. Will not bond to most plastics.
Surface must be sanded and clean, dry and free of oil-based paint, oil, wax, dust and other contaminants. Do not wipe with tack cloth.
Ratio by volume is 2 parts resin A to 1 part hardener B. Ratio by weight is 100 parts resin A to 45 parts hardener B. Do not alter mixing ratio. Mix the resin and hardener together for at least 3 minutes. Large batches need longer mixing for uniform cure.
Best results will be obtained @ 75º F. Colder temperatures will cause system to thicken and cure more slowly. To avoid waste, mix only the quantity that can be used in 20 minutes. Using brush and/or squeegee, apply mixed resin/hardener to surface. To enhance the bond between fill coat and lamination, use a paper towel with denatured alcohol to clean and “bite” into epoxy surface. Apply fill coat no sooner than 8 hours and no later than 24 hours after lamination. If unable to hot-coat within this time frame, roughen entire surface with sandpaper.
Approximately 20 minutes @ 75º F.
48 hours + post cure @ 120° F or 14 days @ 75° F.
Use Fiberglass Hawaii Acetone for cleanup of tools and equipment. Wash hands thoroughly after use with soap and water only.
Applying fiberglass, kevlar, or carbon fibers to surfboard, sailboards, kayaks, canoes, model airplanes, or any other product where superior physical properties and ultraviolet resistance are a design criteria.
Avoid breathing vapors and contact with skin, eyes, or clothing. Hands or other skin areas coming in contact with epoxy should be washed thoroughly with soap and water. Rubber gloves and eye protection should be worn when handling.
*Prices subject to change without notice.
|REGW-K02||Epoxy GuideWrap Quart Kit||Quart||SHOP|
|REGW-K03||Epoxy GuideWrap 1/2 Gal Kit||1/2 Gal||SHOP|
|REGW-K04||Epoxy GuideWrap Gallon Kit||Gallon||SHOP|
|Epoxy GuideWrap 2 Gal Kit||2 Gal||SHOP|
|Epoxy GuideWrap 10 Gal Kit||10 Gal||SHOP|
Material Data Safety Sheets (MSDS)
To request product MSDS please email: Product Support
Phone: (800) 566-2653
Fax: (808) 841-2108